Mentioned, it can weld materials anywhereīetween 18 Ga and 3/16 inches. There are some better, similarly priced machines, one of them would be the Everlast 140E. Taking a look at its weight, it uses transformer technology that is not suitable to use with generators. It is important to note that the recommended breaker should be at least 20 amps to avoid popping any.įor welders who are on the move frequently, if you have to use a generator as a power source then this welder is not suitable for you. This Hobart is designed for Do It Yourself welders so it runs on the regular household power supply. If you weld a lot, it is a great way to save money on welding wire. It is a pain in the butt to get it installed since it is tight, but it does fit. ![]() What differs it from the rest though besides the strong overall built is that it can fit the huge 10-pound spool in it. That is quite a bit of weight for a 100A machine. ![]() It still is really sturdy and portable, but it weighs around 44 pounds. It looks very similar to their other Handlers, but it still differs a bit in weight and dimensions. The wire speed should be infinite, however, which is good. This offers a wide range of settings to pick from, starting at 30 amps up to a maximum of 100 Amps.Īs I said, opposed to most similar class welders, you have much more control over the amperage or voltage settings. Like all Handler models, so does this have a tapped knob voltage control, with 4 different setting options. Check Details On Amazon Controls of the Hobart 100Ĭontrols of the Handler, compared to similar, 90A class welders, is nothing to complain about, to be frank. That is just something to keep in mind before you decide if it is suitable for your workspace. Preferably this wire feeder should be used outdoors unless you have a great ventilation system in place. No matter what I would not weld frames and constructional beams thicker than 3/16, even as an experienced welder.įor some readers, it might be important to note that because the Handler 500572 is a flux core welder, it is only possible to weld mild steel with it. I would not go much thicker unless you are practicing or doing some metal art. It is the maximum rated output by the manufacturer and welding any thicker materials would really be pushing the envelope in my opinion. Basically for every type of job where it is not necessary to weld materials thicker than 3/16 of an inch. Now, it is a perfect welder for exhaust, roll gages, metal art, off-roaders, etc. The FCAW still needs a bit more skill than regular MIG, but with some practice, it is possible to lay strong welds. ![]() How the beads turn out though is another story if you’re a beginner. It really does not require much skill to set up the machine and lay your first beads. Like all wire feeders, so is this easy and intuitive to use. With the reputation of the brand, it is safe to assume this model will easily last for decades to come. Of course, like every machine, it is not perfect and it could use some minor improvements, but let’s not forget that it is designed with practicality in mind. For me, it would be a winner every day of the week and twice on Sundays. To kick off this review, I have to say that for the money, that welder has more than enough to keep you busy for hours on end working on your projects.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |